Sentry US ACSK-EM Instrukcja Użytkownika Pobierz pdf (Strona 9)

ADDING A MASTER CARD (ONLY FOR ZONE 1)

Note: It is advisable to install the Master Card first before installing any User Cards

To Add a Master Card:

1. In Setup Mode, press * key and 7. The mode LED indicator will flash green

indicating there is no master card. If the mode LED indicator turns red, a Master

Card is already stored. To clean up and remove, press * key twice.

2. Swipe Master Card. A long beep means master card was stored.

3. Press # key to exit Setup Mode.

Using Master Card to Enter and Exit Setup Mode:

1. Swipe Master Card. A long beep will sound and the mode LED indicator will flash

yellow. This means that you are in Setup Mode.

2. Exit Setup Mode by swiping Master Card again. Three rapid beeps and the mode

LED indicator will turn green means that you have exited the Setup Mode.

The access control will be locked for 60 seconds if one of the following occurs:

• A wrong code is entered continuously

• An invalid card is swiped 5 times

When a door is opened and then closed, the system will automatically detect the door status

and lock the door even though it is still in delay period (for ZONE 1 only).

IMPORTANT NOTE: The user code must be different from the Programming/Admin Code. The

code of ZONE 1 must be different from that of ZONE 2.

ADDING A USER CARD & CODE

ZONE 1:

1. In Setup Mode, press one number from 000-999 data storage units. Yellow LED

indicator will flash.

2. At the same time, if red LED indicator is flashing, this means the number data

storage unit existed. Press * key twice to clean up. If green LED indicator is flashing,

this means the number data storage unit can add card(s) and password(s).

To add cards and passwords:

1. Enter Setup Mode. The yellow LED indicator will flash.

2. Input a 3-digit number from 000-999 data storage units and the green LED indicator

will also flash.

3. Swipe card and a sound “BI” means the card was successfully added. Then input the

correlative passwords. The length of the password should be the same as the

Programming/Admin Code. After the “BI” sound, this means the card is added and

the passwords are set successfully.

4. Press # key to exit Setup Mode and standby.

To delete cards and passwords:

1. Enter Setup Mode.

2. Input a 3-digit number form 000-999 data storage units. If red LED indicator is on, it

means there is data stored in this set of unit.

3. Press * key twice to delete the card and password/code.

4. Press # key to exit Setup Mode and standby.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Brak uwag

Sentry US ACSK-EM Instrukcja Użytkownika Strona 9